camInstructor Video Blog

This video is taken from our 2D High Speed Toolpath Course where we explore every toolpath parameter inside of these paths.

Here is the link to download the file...

Dynamic Sample File

The video sample here is looking at the Gaps and Motions settings for the 2D Dynamic Mill toolpath. This is the 3rd video of 5 exploring the settings within the 2D Dynamic Mill toolpath.

Other videos in this course explore the chaining methods used, as things are slightly different than your typical 2D toolpath, also, chaining varies a bit depending on which toolpath you are using. Next, we look at each of the 5 toolpaths and the parameters within each. Then, we dive into the use of the Stock setting and its effect. After that, we'll look at the Arc Filtering settings. Finally, we look into Chip Thinning, HEM, and calculating speeds and feeds for these high speed paths.

The course also provides over 30 Mastercam files, a combination of sample files for you to follow along with the 3+ hours of video, and exercise files for you to try out your new found skills.

Want to learn more about Mastercam? Check out;

camInstructor for Teachers - Independent Learners - Students